Carbon numberplate?

Anyone know if this is being done - no luck looking so far, found one possible source but it has since gone into liquidation.

Trying to find a company who will make up a rear numberplate using carbon sheet material instead of the usual ABS. I'm looking for a (sort of- bit smaller than), legal size with the yellow reflective surface applied onto the carbon but with the letters cut out so they remain a carbon black weave finish.

I'm not interested in looking at any fake carbon effect stuff though. Only the genuine article please

Have you tried these guys?

http://www.carbonmods.co.uk/
If you get the carbon and the reflective film, I can use my vinyl cutter to chop out the letters for you.

Owwww, form an orderly queue below!

Good advice and link Millar!

Just ordered a piece of high quality 3mm pre-preg carbon sheet for about £30 and a couple of sheets of reflective yellow vinyl from Ebay for about £3. I'll have a go at cutting the letters myself first but if I can't do it precisely enough I might take you up on your offer.

Think this plate will look good! I'll post pictures when complete.