Right I know this is not the correct way for these to get mounted but they follow the shape of the duck bill quite nice what do u recon GOOD OR BAD?????
what do u guys think??????
10 posts · Started by gfunkmc · 08 Feb 2013
Post 2 by MADDOG53,
#2What am I looking for pipes are on backwards,,,,,,,,,,,,,,,,
Post 3 by DribbleDuke,
#3I have always thought the orange tank looks better.
Is that geenish blue thing a boogie board?
Dunlop rubber for the feet, they have a D designation too?
Is that geenish blue thing a boogie board?
Dunlop rubber for the feet, they have a D designation too?
Post 4 by tigerstyletroy,
#4I like the quote on the plate. Mount your exhausts however you prefer. It looks normal, I see what you mean by following the curve of the duckbill. The only people that would notice would be other SD'ers.
Post 5 by bic_bicknell,
#5How are you fixing them at that angle? On my titanium system the carbon hangers and the spring clips dictate a vertical position. You don't get any choice. Do you have bolt fixings where the silencers join the exhaust pipes so you can lock them at any angle? If you fitted them like this with a single seat they would look splayed out. They look right vertical on my bike but it's just a matter of taste I suppose.
Post 6 by gfunkmc,
#6Hi bick they are the spring fixings (under slight tension) but im using the akra mounts in the subframe .... problem is when I put the two brothers pipes on a few years ago the akra mounts kept twisting so I had them welded in the subframe at an angle good for the two bros pipes (slight mistake lol) so iv put tge strapps for these akras aback to front to mach the angle of the mounts I think they look ok (not great) but without grinding the mounts out the frame or some taper packers I think they will have to stay like it ... just in the back of my head that they r not right
Post 7 by scamb66,
#7Get some new Akra decals put em on straight and I dont think you would notice the difference.
Post 8 by gfunkmc,
#8Post missing
This post could not be recovered from the original forum.
Post 9 by gfunkmc,
#9Could you do me a favour matey and just measure the length of the sleeve? The cans I'm looking at don't have the cone and I can get the inlet pipe length made to order.
I do have the Akra Y-piece already, although I'm not sure whether off an SD or SDR - should it be obvious ? My bike's a standard '07 SD.
I have the Akra mounting brackets already too. I used to have TubeTech 2T-R on it see.
D[/quote]
The lenght is 13.5" matey and the akra y peice is not obvious its only coz I had tge 2 side by side I noticed
I do have the Akra Y-piece already, although I'm not sure whether off an SD or SDR - should it be obvious ? My bike's a standard '07 SD.
I have the Akra mounting brackets already too. I used to have TubeTech 2T-R on it see.
D[/quote]
The lenght is 13.5" matey and the akra y peice is not obvious its only coz I had tge 2 side by side I noticed
Post 10 by gfunkmc,
#10Its only the length of the peices that go into the cans its about 2-3"
End of archived topic · Posting is closedBack to top ↑
← Back to General banter