Best tail tidy

Which one is the best Evotech,,,,RG,,,,really hate to cut up all the stock parts,,,, and I would like to keep the duck bill,,,, and would like to can the stock winkers for,,,,,,,,,,,,,,,,,,, an easy install would be nice as well,,,,

Sounds like you are after the same thing I was when I was looking. The only one that fits the bill is the R&G. I elected to go with Rizomas in liue of the signals that came with the kit. My buddy is using the R&G signals on his CBR600.

Works great and looks even better.

See my post titled: "Latest mods"

John

As above, the RnG is more than likely what you are after, but have a look at the Rizoma as well.

If you don't want to cut then the R&G is fine. Personally the duck bill had to go so I went with Evotech

MD-
The cleanest (and cheapest) one I found was one I made. It will require no cutting of plastic, only the removal of the under tray (6 screws). It mounts to the second from the rear stock under tray holes. I'm making another version and can easily make 2. I'll get some picks and you can tell me what you think. If you like it, I'll make you one. I saw another member here that has done the same thing.

Stac

OK. I didnt get time to make the second version but here are pics of what I made that I am currently using. As I mentioned, I plan on extending the portion that is bolted to the bike, farther forward to reach the next set of bolts. This will give coverage back to where the stock under tray was.

Maddog-I'll send you a PM

From behind (

what it looks like from behind (nudge nudge)

tail2.jpg (43.27 KiB) Viewed 1197 times

underneath

tail3.jpg (52.76 KiB) Viewed 1197 times

side

IMG_1170.jpg (41.66 KiB) Viewed 1197 times

Here is the SDTTv2 (Superduke Tidy tail version 2). There is now coverage back to where the original plastics were removed. Simple and effective, and cost me nothing but a little time. Blinker mounts were not added but that is simple and can be put anywhere.

this has a slight bend to fit the contour underneath

IMG_1179.jpg (95.38 KiB) Viewed 1133 times

this has a slight bend to fit the contour underneath

IMG_1179.jpg (95.38 KiB) Viewed 1133 times

Maddog-I can put blinkers anywhere. Let me know if you will use stock or aftermarket blinkers. If you ask me you need and integrated tail light. I saw your post on "show you SD" and yours is looking good. Lose the blinkers.

Dribble-I can make one of these for you and bring it to Moto GP. You want?

Stac

Your right about loosing the blinkers,,,,,and I have been looking into the intergrated set-up,,, makes more sense that buying some other ugly blinks,,,, I kinda like what Klinck did on his with a couple of LED strips,,,,,what did you do about the plate light,,,don't see it

The stocker can be made to work but I prefer the small led lights. I dont have anything now and might not use anything. A lot of CA bikes have plates mounted in odd spots with no light, so I should be safe.
Something like these would work well... http://www.d2moto.com/p-5575-silver-mot ... bolts.aspx

Stac