Clear or smoke LED Tail light???

Hey guys, looking at getting an integrated LED tail light off ebay.....not sure which one will look better on my black SD....clear or smoke?

Also, is the flasher relay situated behind the headlight mask?

Anyone who is running an LED tail light set-up, is the wiring up part of it easy enough to do?...I have read that getting the actual tail light in & out can be a biatch!!!.....lol

Thanks a lot, cheers Rob

+1 smoke tail-light.
For a man of your capabilities, should be piece of piss to remove tail-light assembly.

Smoke smoke smoke duuuuuude.

Yep, go for the smoked version!

I got mine from http://2a4.fr
Getting the taillight off is annoying (to say the least). After trying al kinds of tools I've eventually sawn a 10mm wrench in half.
The tailligt I got came with the right connector for the light and bullet connectors for the blinkers. The blinkers don't come with a ground wire, the ground wire from the taillight is used for that. The blinker wires did not come labled so I had to try which color was which side.
The flasher relay is behind the headlight mask and is pretty small. The new was almost twice the size. It came with the right connector so it was a straight swap (and a bit of a fiddle to get is back in the place where the original relay was located).

Seat cowl looks like mine ,, nice huh finished off look,,, e-bay item from Greese, took a week to get to the US,,,color match is close enough as is ,,,,,,,,,

http://cgi.ebay.com/ebaymotors/KTM-Supe ... 3caf55ee49

Get the smoke. A monkey could install it.

http://www.youtube.com/watch?v=z9cK4Bjr_JI

My seat cowl is the one MADDOG53 linked to.
The cowl is glossy black and like said matches the black SD's color pretty well. I found it to scratch very easily...
I had mine painted in the same color as my bike (titanium) with a matte black stripe in the middle.
It secures with two brackets with screws on the side and also has a bit that secures under the end of your seat.