Cylinder block off plate(remove the US emissions). Picked up the KTM kit . The kit shows in the instructions that you have to drain the radiator fluid to move it for the right side cylinder. Anyone with experience with this install have any advise..
cylindar block off plate
7 posts · Started by superduke08 · 18 Jul 2010
Post 2 by BASH69,
#2It can be done without removal dude, remove tank spoiler and move water bottle to 1 side, a 8mm ring spanner and time will be ya friend here, its fiddly and tight but it can be done (and a WHOLE lot easier than refilling the cooling system )
Good Luck
Good Luck
Post 3 by superduke08,
#3Thanks bigash
Maybe I will take some photos as I go as reference for anyone else.
Maybe I will take some photos as I go as reference for anyone else.
Post 4 by samba,
#4it takes ages....
I took a few pics when I was doing mine last week... I did have the tank and airbox off so they probably are of no use to you, but here's a couple anyway
I took a few pics when I was doing mine last week... I did have the tank and airbox off so they probably are of no use to you, but here's a couple anyway
Post 5 by ktmguy,
#5Post missing
This post could not be recovered from the original forum.
Post 6 by superduke08,
#6Post missing
This post could not be recovered from the original forum.
Post 7 by samba,
#7Post missing
This post could not be recovered from the original forum.
End of archived topic · Posting is closedBack to top ↑
← Back to Hooliganism