Hello folks. I am seeking to put a spoiler on the 1290, pretty similar on the one 990 has. Found these two and wondering if any other comrade has already installed either of those.
Front spoiler/belly for 1290
14 posts · Started by stel_0 · 17 May 2015
Post 2 by ktmguy,
#2Surprisingly both look good on the bike!
Like the SW as it probably is just enough to save the covers also in an off.
Like the SW as it probably is just enough to save the covers also in an off.
Post 3 by ktmguy,
#3Geees i thought they both looked very ordinary - it just goes to show I have no idea!
i thought my bellypan design looked ok but maybe it too will look like sh1t when its finished. I have put in soooooo much effort over the past few weeks so I hope it doesnt look too bad when its finally layed up in CF!
i thought my bellypan design looked ok but maybe it too will look like sh1t when its finished. I have put in soooooo much effort over the past few weeks so I hope it doesnt look too bad when its finally layed up in CF!
Post 4 by alobar,
#4Post missing
This post could not be recovered from the original forum.
Post 5 by jmann,
#5Stel why do you want to put a bellypan on your bike?
In my opinion i think that they only thing they do, is to add weight and to damage the look of the bike.
In my opinion i think that they only thing they do, is to add weight and to damage the look of the bike.
Post 6 by stel_0,
#6Post missing
This post could not be recovered from the original forum.
Post 7 by bauer,
#7I'm putting my money on comrade abc's design.
Post 8 by stel_0,
#8They do add weight indeed, but kind of minor. They protect the front part of the cylinders, alongside with the engine covers(ktmguy the other one protects the covers not the sw). Nevertheless I think the look is good
Post 9 by stel_0,
#9Post missing
This post could not be recovered from the original forum.
Post 10 by bauer,
#10Post missing
This post could not be recovered from the original forum.
Post 11 by alobar,
#11Just received the 2nd one I posted. The build quality seems very good and it's easy to install it.
One question. If I unscrew bolts from areas around the engine covers should I screw them with a specific torque ?
One question. If I unscrew bolts from areas around the engine covers should I screw them with a specific torque ?
Post 12 by stel_0,
#12Post missing
This post could not be recovered from the original forum.
Post 13 by stel_0,
#13Where should I find the exact torques needed ?
Post 14 by Bermo KTM,
#14In the technical data of the repair manual there's a table with all the engine tightening torques
End of archived topic · Posting is closedBack to top ↑
← Back to Hooliganism