Post missing
This post could not be recovered from the original forum.
How to clean the cast ali bits
12 posts · Started by Reb · 25 May 2010
Post 2 by Duke4Dirk,
#2Post missing
This post could not be recovered from the original forum.
Post 3 by Colonel_Klinck,
#3A brush, WD-40 or kerosene. WD-40 is essentially kerosene.
I bet you boys over there on the island use a lot of WD!?
I bet you boys over there on the island use a lot of WD!?
Post 4 by ktmguy,
#4Post missing
This post could not be recovered from the original forum.
Post 5 by DukeofCornwall,
#5Post missing
This post could not be recovered from the original forum.
Post 6 by arashi,
#6Post missing
This post could not be recovered from the original forum.
Post 7 by Stratkat,
#7Just don't get any WD40 on the brake pads or brake disc!
Post 8 by Colonel_Klinck,
#8Post missing
This post could not be recovered from the original forum.
Post 9 by arashi,
#9Post missing
This post could not be recovered from the original forum.
Post 10 by Petesbandit1200,
#10Post missing
This post could not be recovered from the original forum.
Post 11 by ShadeTheChangingMan,
#11Post missing
This post could not be recovered from the original forum.
Post 12 by Twisted Jester,
#12WD40 & a clean cloth - keep it off the rotors though, and if you do, don't spin the wheel until you've cleaned it off otherwise you'll contaminate your pads.
End of archived topic · Posting is closedBack to top ↑
← Back to Hooliganism