Read-only archiveOriginal forum posts · 2005–2020

Looking for a running light wire?

7 posts · Started by tonyteeth · 19 Nov 2015

Archived topic · Replies closedJump to last post ↓

Post 1 by tonyteeth,

#1
So I ordered snap-on fork running (white)/signal (amber) lights to replace the front blinkers on my SD1290 (link below). It comes with Drugz Turn Signal Circuits (link below) which requires a third running light wire. My thought is to tap into the LED running lights above the headlight. There are 3 wires brown, white, and white/yellow as shown in my pic. Anybody have knowledge with the wiring? Am I on the right track?
Image

Post 2 by tonyteeth,

#2
Basically, I'm looking for a running light wire in the front of the bike.

Post 3 by Sarasota_Steve,

#3
Tony,

I think it's found under the seat on the 1290. If you do a search I'm pretty sure it was discussed recently.


Sarasota_Steve
08 990 SDR

Post 4 by tonyteeth,

#4
Yes, I am aware of that wire but I was hoping to find a 12v in the headlight assembly so I dont have to run a wire. The headlamp itself does have a 12v. I might tap into that. Every other wire I've tested come up with about 6-7 volts.

Post 5 by DribbleDuke,

#5
Post missing

This post could not be recovered from the original forum.

Post 6 by tonyteeth,

#6
Post missing

This post could not be recovered from the original forum.

Post 7 by tonyteeth,

#7
Install is complete
End of archived topic · Posting is closedBack to top ↑
← Back to Hooliganism