Rizoma handlebars

Been reading up a bit, just two quick questions before I order.

1. These are the ones people here are using, right? http://www.twinshack.co.uk/prods/375.html

2. It seems everyone is using them with OEM clamps. Has anyone had any issues at all fitting the bars?

Cheers.

I know approximately how much narrower they (Rizoma) are compared to the OEM handlebars, but how much lower would you say they are? Anyone?

When I looked into it

LSL were lowest (and because they start off much wider you cut them down to suit)
Ducati Monster next
then
Rizoma

Same order for width

Trouble is, there are two Rizomas. Height 30 mm (MA005B) and 50 mm (MA008B). Which one is the one most use?

50mm is the same as standard

This picture (NICKED FROM THE OTHER THREAD) shows Monster bars (top) Rizomas 30mm (Middle) and Standard Bars Bottom

[/quote]

Cheers, went with the 005:s.

Thanks for the help.

I ended up chopping about 20mm off each end of the MA005 bar, just felt it was a little too wide. Might have been the bar end mirrors that made the final decision for me though.
Finding it much more comfortable than the Monster bar.