Post missing
This post could not be recovered from the original forum.
Scotts Steering Damper
10 posts · Started by easze76 · 23 Jul 2009
Post 2 by drswade,
#2Post missing
This post could not be recovered from the original forum.
Post 3 by easze76,
#3Thanks for the response, I actually emailed somebody over at KTMtwins and they metioned that some SD's actually have the handle bar mounts upside down, not the scotts top bit, they told me to rotate them 180 and should be all good. At work so cant really verify this but they say some bikes they've seen with no ryme or reason have shown up upside down which would put it off about 1/4 inch .... Weird
Post 4 by easze76,
#4Post missing
This post could not be recovered from the original forum.
Post 5 by easze76,
#5like I said, sounds weird, but I guess I'll check it out. Like I said the top barclamp is really the only thing you can conceivably put on backwards in the scotts kit.... Its on correctly so where the extra 1/4 inch is coming from I dont know.. I just hope the answer dosent lie with the previous owner
Post 6 by drswade,
#6Post missing
This post could not be recovered from the original forum.
Post 7 by easze76,
#7Post missing
This post could not be recovered from the original forum.
Post 8 by drswade,
#8Post missing
This post could not be recovered from the original forum.
Post 9 by easze76,
#9Post missing
This post could not be recovered from the original forum.
Post 10 by easze76,
#10Thanks, going to have at it tomorrow night I'll keep you posted
End of archived topic · Posting is closedBack to top ↑
← Back to Hooliganism