mask up grade help please

Ok ive been looking back in old posts but can not seem to find the one im looking for
ive just put the new shape mask on but need help with the wiring
i have the new loom fitted clocks all light up but alarm light flashers dont no about taco not started it yet bit to late
i have the new 3 pin tem plug not fitted
& i can remember reading about the alarm wire but all the links to the photos are now dead ?
so can any one paste the link up fitting new mask for dummies
or put it in a post the easy way to do it do i need to cut any wires / wear do they go ?
and i must say what a bitch the new mask is to build up i built it around the light


thanks for now

i keep telling everyone it's a bitch of a job!! haha

the temp plug isn't necessary for everything to work properly - I didn't do it with mine and it worked fine...

However I'm not sure I can help - the problem I had when I did it was no lights on except FI flashing...but your clocks are lighting up, so it's not the same problem...

The cause of my problem was the 2-pin alarm connector, however. Once I'd connected that up everything was peachy

look here.
viewtopic.php?t=5291

Yer i will have a look as soon as i get home think this is the one ive been reading but the links are dead i will look again later thanks

Ok the reve counter is now working ive done the blue & white wire but when i come to start it up its reves a few times then cuts out could this be the alarm from the new clocks ?
(i have no alarm on the bike)
now im stuck again

thanks for now

If the bike haven't got normal idle it is because of the 3 pin temp sensor maybe.. (Without it, the ECU thinks the engine warm enough and set to normal low idle - 1.400 RPM which is very low for a cold engine)

Someone has problems with the alarm wiring on the forum. I didn't made it to the tacho and worked fine (I bought an alarm lately).

is it possible to get those wiring pictures somewhere? seems that the album links are not working.

Maybe I can upload them again at the weekend..

Thanks for the info the only thing ive not done is the 3 pin temp sensor i have it so just need to read up on the 3rd wire so i take it the two wires i have are to the 3 pin temp sensor ?