Read-only archiveOriginal forum posts · 2005–2020

Best map for Powercommander / slipons?

9 posts · Started by Ruotka · 20 Jul 2007

Archived topic · Replies closedJump to last post ↓
Post missing

This post could not be recovered from the original forum.

All the maps on the dynojet website are free to download...

Which one is the best? Well that depends on which KTM mapping you have in your ECU and your own bike setup. You'll have to load and test them yourself if you're not prepared to put your bike on a dyno.

If you have the standard mapping in you ECU, make sure you only use those pc3 maps that have been written using that mapping. And likewise for the 'akro' tune.

You'll lose Hp with the snorkel removed.
I have fitted a pair of Akros to my R and think the dealer has re-programmed the electronics for them without the cats. Will a Powercommander add anything to performance over and above this ??
Post missing

This post could not be recovered from the original forum.

I find the throttle response excellent. I am still running the bike in but I have to say that this is my first KTM and I am very impressed. At low revs the engine is smoother than my Blade wich had a Pwr Cmdr and Akro fitted.
I have this M925-507 map now and snorkel is off, SD runs very good.
Before I put slipons and power commander SD was on dyno and it get out 112hp on rear wheel with orginal exhaust. I take again SD on Dyno put first I like to find best map.
I have ECU orginal map, no remapping before...

If snorkel is off... it get's better air??? Or what? Lose it torque?
I think it get better air on top rpm's?
Runs worse with snorkel off.... Feels ok but the dyno says otherwise.

Image
Post missing

This post could not be recovered from the original forum.

Okey!
Now I have snorkel on... Thank's!
I have to take laptop with me when I go to Dyno. And try different map's.
End of archived topic · Posting is closedBack to top ↑
← Back to Technical - Dr F's Words of Wisdom