Post missing
This post could not be recovered from the original forum.
Blinking FI light after SAS removal
4 posts · Started by 990Glen · 07 Aug 2007
Post 2 by KTMax,
#2Post missing
This post could not be recovered from the original forum.
Post 3 by Dr F,
#3With the full Akra map you'll get an error message. In any case there are two simple solutions.
Remove everything except the SAS valve. But this doesn't look as nice. Second is to replace the SAS valve by a resistor fooling the ECU that's the SAS valve. While the SAS valve is only 20 Ohms it's important that the value of the replacing resistor must be between 600 and 1000 Ohms to keep it from getting hot. Works perfect. No errors, regardless the map installed and is 100% reliable. I used the connector and wires from the SAS valve.
Remove everything except the SAS valve. But this doesn't look as nice. Second is to replace the SAS valve by a resistor fooling the ECU that's the SAS valve. While the SAS valve is only 20 Ohms it's important that the value of the replacing resistor must be between 600 and 1000 Ohms to keep it from getting hot. Works perfect. No errors, regardless the map installed and is 100% reliable. I used the connector and wires from the SAS valve.
Post 4 by superDUKE220,
#4Post missing
This post could not be recovered from the original forum.
End of archived topic · Posting is closedBack to top ↑
← Back to Technical - Dr F's Words of Wisdom