Post missing
This post could not be recovered from the original forum.
Clutch switch issue
11 posts · Started by PBRnr · 11 Oct 2010
Post 2 by cdlabate,
#2Post missing
This post could not be recovered from the original forum.
Post 3 by kuerbis,
#3Post missing
This post could not be recovered from the original forum.
Post 4 by PBRnr,
#4Post missing
This post could not be recovered from the original forum.
Post 5 by Colonel_Klinck,
#5Post missing
This post could not be recovered from the original forum.
Post 6 by kuerbis,
#6Post missing
This post could not be recovered from the original forum.
Post 7 by MADDOG53,
#7Post missing
This post could not be recovered from the original forum.
Post 8 by PBRnr,
#8Post missing
This post could not be recovered from the original forum.
Post 9 by MADDOG53,
#9Post missing
This post could not be recovered from the original forum.
Post 10 by PBRnr,
#10Post missing
This post could not be recovered from the original forum.
Post 11 by MADDOG53,
#11No bro , it's for electrical conectors, they're round tubes 4 inches long or so packed in a variety of three or four sizes, smallest is 1/8 inch I think, perfect to start, slide it on the pin ,heat,cut to length, it's going nowhere, then the next size and so forth, until it's a done deal,,, makes it just big enough to do the job,, Home Depot , by all the connectors and stuff,, 3 bucks,,,,
End of archived topic · Posting is closedBack to top ↑
← Back to Technical - Dr F's Words of Wisdom