Read-only archiveOriginal forum posts · 2005–2020

Footpeg clearance?

7 posts · Started by rocketchick · 09 May 2013

Archived topic · Replies closedJump to last post ↓

Post 1 by rocketchick,

#1
I am a bit concerned how much clearance i have before or if I touch my solid non flip pegs.
I'm thinking I'll run out of tyre before I touch the peg, can anybody confirm if they have touched their peg?
I have the P&P rearsets.

Post 2 by KTM666,

#2
..touched them down and worn half and inch off them

......but that was standard pegs which are lower and wider ...so you have rear sets which will be higher and narrower

Post 3 by ktmguy,

#3
I have the PP also and have them in the highest position. I don't think they will touch before the clutch or flywheel cover.
I know the original touched down but these are higher and narrower.
The best way to test is to fit a gopro or so on the back or passenger peg and go for a ride.

Would be intresting to know.

Post 4 by rocketchick,

#4
Post missing

This post could not be recovered from the original forum.

Post 5 by jambox,

#5
Post missing

This post could not be recovered from the original forum.

Post 6 by Tony the Tiger,

#6
Post missing

This post could not be recovered from the original forum.

Post 7 by ktmguy,

#7
My bad!
End of archived topic · Posting is closedBack to top ↑
← Back to Technical - Dr F's Words of Wisdom