Help me identify these parts

Could someone help me figure out what these bits are? They were just included in my "box of bits" when I bought the bike.

First all these smaller spacers and bolts:

The black bushes/spacers are plastic.

And, then these ones...:


Anyone..? Thanks!

I dunno what the top pic is of/for....but the bottom one is the mountings for the hangers of the standard exhaust for the SD. They go into the rear subframe of the bike and then the standard cans have a bit each side that slides inot the hole of those parts. The rubber dampens the vibes/noise going into the frame. So basically, you only need em if you're going to fit standard cans back on it.

Hmmm. I didn't get those with my SDR (but the seat's quite high enough at the low setting)

Plipton how do you knoe its at the low setting ! it mite be at the high setting and you havent noticed it , hence no spairs .

Just to add - the silver spacer in the top pic doesn't go with the seat spacer kit, but rather it goes with the side stand sensor resistor kit.