help needed (gauges not working)

hi road bike into town to do rwc check every thing was working turned bike off went into shop then went to start bike and no gauges , no sweep of taco no lights nothing bike starts and runs fine ,checked fuses there fine , do gouges just stop working this is a first for me

The gauges can - I'd check the gauge console's connection (cable connector) first - it's possible it's partially (or completely) disconnected, or became unseated.

Worst case - the console gave it up (it's dead), and that happens too. Chronic enough to where KTM redesigned it, and if you have to replace it, it will appear a little different.

thanks for that but i dont believe it is the gauges im now tracing all the wires trying to find any broken wires but the wire diagrams only show color not what they are

well now the fi light is flashing a least that now working also the lcd very faintly saying soft 33 so battery charger is on now

Could be rectifier?

checked that its a strange one

Is the speedo unit backlight still working?

I've had a couple of units fail but also had problems with broken wires/loose connections to the speedo unit - have a read thru' viewtopic.php?f=5&t=10424&hilit=dat+soft

thanks read that and the gauges have power when your gauges shat them selve did they just stop working or act up for awhile

check if . if it is, your speedo is probably suffering from moisture problems.

If you are feeling adventurous just open it up and see if it can be repaired ()

another question the fi light flashes with the key of is that normal cheers

I now believe it must be the gauges

whatyearisyourbike
If you need to replace your unit, I believe they updated the unit in ....SWAG......09.
So look for a updated unit.
If you have a 07 and order a 07 unit.....you just might get an 07 unit that does not take to moisture as well as the updated unit.
I say this because I bought a new unit for my 08 and I see moisture behind the screen.