allright guys,
I had my local garage refit the front wheel bearing/bushes this morning along with the tyre, and all seemed fine. I fitted the discs back on, and set about mounting the thing again.
As some point, I think while trying to get the spindle through, I think I've upset it all, as my LHS shaft seal ring now sits about 2mm out, as does the bearing behind it...
can I first confirm that it's all supposed to be totally flush?
and trying to smack it back through isn't really doing much - do I have to pull it all out and start again? if so....how?
any suggestions?
I had my local garage refit the front wheel bearing/bushes this morning along with the tyre, and all seemed fine. I fitted the discs back on, and set about mounting the thing again.
As some point, I think while trying to get the spindle through, I think I've upset it all, as my LHS shaft seal ring now sits about 2mm out, as does the bearing behind it...
can I first confirm that it's all supposed to be totally flush?
and trying to smack it back through isn't really doing much - do I have to pull it all out and start again? if so....how?
any suggestions?