Nautilus Horn

I made an "L" shaped bracket, about 3 x 1.5 cm, short end bolts to the horn, long goes under the R&G puck (upper left). finally installed it last night, fits well, looks good! wires reach with minimal re-routing. i'll try to post some pics this evening

Fitted mine under the front spoiler by using both plates supplied, bolted one end of each to the OE mounting holes but not tightening them, then bring the front of each together to form a triangle, push the horn mount bolt though the hole(both plates) and tighten, now bend horn through 90 degrees and tighten the two engine mount bolts. Snug fit under the spoiler but far enough forward to keep it away from the header