Oil leak still?!

I can't seem to locate the oil leak I'm having on the alternator side of the cover. I replaced balancer shaft seal. Replaced crank breather clamps, tightened them and tightened correspond nuts and such. Included album from its area. Thanks.

Oil leak https://imgur.com/gallery/5QaPt

After you replaced the balance shaft seal did you pull the airbox and clean all the oil out of it as well as clean your air filter?

No air box. Rottweiler intake.

To add. I did take everything off down to the throttle bodies and cleaned it allm

Is one way valve installed right way round?

I replaced the one way valve last night and I'm reassembling this morning. I purchased the Oetiker clamping tool for the stepless stainless steel clamps to do the job properly. I'm loving the stepless ear clamps. I want to buy a whole kit sizing between 1/4" and 1 1/8".

Any oil on front cam cover?

Hi!

I still having a oil leak too mate, losing all the patience with the bike

First of all try to be sure where the oil comes.

I changed the shaft seal last summer but yesterday I took off the rubber tube of the ignition cover and it's spiting a lot of oil.



In my case i'm sure that the seal is broken.... AGAIN

If you check the tube and is dry the problem comes from the ignition or cam cover seal. Check them all.

Some bolts have cu-seal rings, did you put them?

Good luck mate!

I think i have oil leaking from the clutch slave. I can see it bubbling behind the seal. Anyone able to help me with all gaksets I should replace right there

Have a look at the parts fiche - if it's engine oil leaking, there's a clutch pushrod seal that'll need replacing - this seal is one of the 'weakest' crankcase seals and, commonly, leaks here indicate a pressurised crankcase, particularly if, as you say, it's 'bubbling' out, ie a blocked or failed crankcase breather set up.

if it's clutch oil leaking, time to replace/rebuild clutch slave