I noticed on top of what I believe is called the clutch "slave cylinder" (not that I really understand what that is...but its right where the clutch line reaches the engine) there is a little "grease" fitting...well, actually a fairly large one, bigger than the ones on the levers anyway. It has a little rubber cover that says "oil" on it. What is this about? I don't find a mention of it in the factory repair manual...What sort of oil?..how?...when?...what does it do?
oil the slave cylinder?
13 posts · Started by robinpeck · 19 Oct 2008
Post 2 by kendo57,
#2Yes the clutch uses hydraulic oil SAE10 i think not brake fluid.
You can use fork oil i believe.
You can use fork oil i believe.
Post 3 by SDRmaniac,
#3Post missing
This post could not be recovered from the original forum.
Post 4 by robinpeck,
#4Post missing
This post could not be recovered from the original forum.
Post 5 by 9nine0,
#5Post missing
This post could not be recovered from the original forum.
Post 6 by kendo57,
#6Did you get spare parts books with your bike? If you did, look in the back of the book for the clutch back bleed kit and the mineral oil. Only use KTM mineral oil
Post 7 by robinpeck,
#7Post missing
This post could not be recovered from the original forum.
Post 8 by kendo57,
#8Post missing
This post could not be recovered from the original forum.
Post 9 by robinpeck,
#9Post missing
This post could not be recovered from the original forum.
Post 10 by 9nine0,
#10Post missing
This post could not be recovered from the original forum.
Post 11 by weeksy,
#11Post missing
This post could not be recovered from the original forum.
Post 12 by 9nine0,
#12Post missing
This post could not be recovered from the original forum.
Post 13 by SDRmaniac,
#13whare to send it. It's orange....
End of archived topic · Posting is closedBack to top ↑
← Back to Technical - Dr F's Words of Wisdom