Removing PCIII USB?

Hi Folks, i want to remove my PC III USB from my SD. After this i can load a map with TuneEcu, cable is already delivered.

But now the difficult part, removing the PCIII. It seems to be connected to two large plugs right behind the radiator. How do you disconnect these plugs and if necessary reconnect everything to it's original state?

Unplug PC111 plugs and replug the two halves left (which are the bikes wiring harness) back togeather....if that makes sense

As above, just unplug both connectors and remove PCIII plug back together and done. While you there clean and lube the connector to avoid dramas later.
Referred to in other treads as the BFC.
Also don't forget the swap cyl 1 with cyl 2 map before importing! e.g. KTM - tuneecu front cyl is 2 in PCIII front cyl is 1!