Read-only archiveOriginal forum posts · 2005–2020

Resetting the 2007 SD speedo

10 posts · Started by 9nine0 · 08 Oct 2007

Archived topic · Replies closedJump to last post ↓

Post 1 by 9nine0,

#1
The reset the wheel size on the 2007 SD go to the Trip 2 screen and hold the mode button for at least 10 seconds and the 1879 length will appear. Hitting the mode button will increase the size by 1 mm and hitting the set button will descrease the size by 1 mm. When complete hit the mode AND the set button at the same time to return to the normal screen.

Post 2 by Dr F,

#2
Usefull stuff that thanks. Should that be millimeters though, not inches, a wheel 1879 inches in circumference (about 50 feet diameter !) would look a little out of place on the SD

Post 3 by 9nine0,

#3
Post missing

This post could not be recovered from the original forum.

Post 4 by Resmas,

#4
hi people,
i have tried this procedure but it didn´t work for me. I recently bought a new speedometer and it looks like it´s from 2010, it is set for a 2210mm wheel (21``) and so it reads a little bit above in speed. The buttons also are not round but straight.
Here ´s a pic of the speedo




Would appreciate some help.
thks
Luis

Post 5 by ...BUZZ...,

#5
on the earlier dukes the 17ws flash's up,am i right in thinking this is the wheel size in inch's as the clocks on the earlier ones are off a different bike..???

Post 6 by Resmas,

#6
Post missing

This post could not be recovered from the original forum.

Post 7 by ktmguy,

#7
Post missing

This post could not be recovered from the original forum.

Post 8 by Resmas,

#8
Post missing

This post could not be recovered from the original forum.

Post 10 by ktmguy,

#10
Post missing

This post could not be recovered from the original forum.

End of archived topic · Posting is closedBack to top ↑
← Back to Technical - Dr F's Words of Wisdom