Post missing
This post could not be recovered from the original forum.
Seemingly Excessive Vibration with running Motobox?
24 posts · Started by MishMash · 20 Apr 2010
Post 2 by Jaybiker,
#2Post missing
This post could not be recovered from the original forum.
Post 3 by MishMash,
#3Post missing
This post could not be recovered from the original forum.
Post 4 by Stratkat,
#4Post missing
This post could not be recovered from the original forum.
Post 5 by ...BUZZ...,
#5Post missing
This post could not be recovered from the original forum.
Post 6 by Superdan,
#6Post missing
This post could not be recovered from the original forum.
Post 7 by MishMash,
#7Post missing
This post could not be recovered from the original forum.
Post 8 by kuerbis,
#8Post missing
This post could not be recovered from the original forum.
Post 9 by Colonel_Klinck,
#9Post missing
This post could not be recovered from the original forum.
Post 10 by bic_bicknell,
#10Post missing
This post could not be recovered from the original forum.
Post 11 by MishMash,
#11Post missing
This post could not be recovered from the original forum.
Post 12 by Lowrance,
#12Post missing
This post could not be recovered from the original forum.
Post 13 by Stratkat,
#13Post missing
This post could not be recovered from the original forum.
Post 14 by DribbleDuke,
#14Post missing
This post could not be recovered from the original forum.
Post 15 by Lowrance,
#15Post missing
This post could not be recovered from the original forum.
Post 16 by trackday junkie,
#16Post missing
This post could not be recovered from the original forum.
Post 17 by Stratkat,
#17Post missing
This post could not be recovered from the original forum.
Post 18 by Lowrance,
#18Post missing
This post could not be recovered from the original forum.
Post 19 by MishMash,
#19Post missing
This post could not be recovered from the original forum.
Post 20 by ShadeTheChangingMan,
#20Get that AKra map NOW mate, dont thrash it until you do, you risk valve damage from overheating!
The Leos make it run lean below 4krpm even WITH Akra map.
Also, when they do valve clearances they do not check the valves themselves so you will not get a report on any such damage. It's only shims under the buckets at the end of the valve stems.
BTW SD idle is about 1500rpm but dont trust your rev counter to indicate it that accurately. Your dealer can check it at service...they will also NOT balance throttle bodies unless you ask them to, and some wont do it even then!
The Leos make it run lean below 4krpm even WITH Akra map.
Also, when they do valve clearances they do not check the valves themselves so you will not get a report on any such damage. It's only shims under the buckets at the end of the valve stems.
BTW SD idle is about 1500rpm but dont trust your rev counter to indicate it that accurately. Your dealer can check it at service...they will also NOT balance throttle bodies unless you ask them to, and some wont do it even then!
Post 21 by harvester,
#21Post missing
This post could not be recovered from the original forum.
Post 22 by ShadeTheChangingMan,
#22Post missing
This post could not be recovered from the original forum.
Post 23 by harvester,
#23Post missing
This post could not be recovered from the original forum.
Post 24 by ktmguy,
#24Post missing
This post could not be recovered from the original forum.
End of archived topic · Posting is closedBack to top ↑
← Back to Technical - Dr F's Words of Wisdom