Post missing
This post could not be recovered from the original forum.
Swing arm spools
20 posts · Started by Lowrance · 17 Jul 2008
Post 2 by Thule,
#2I just ordered some from KTM Twins. I haven't gotten them yet so I can't really give a review on them though
Post 3 by Lowrance,
#3Post missing
This post could not be recovered from the original forum.
Post 4 by topendz,
#4Post missing
This post could not be recovered from the original forum.
Post 5 by IanYoung,
#5Post missing
This post could not be recovered from the original forum.
Post 6 by kuerbis,
#6Post missing
This post could not be recovered from the original forum.
Post 7 by Dragonrider69,
#7Post missing
This post could not be recovered from the original forum.
Post 8 by snow,
#8Post missing
This post could not be recovered from the original forum.
Post 9 by smoky,
#9Post missing
This post could not be recovered from the original forum.
Post 10 by TBird,
#10Post missing
This post could not be recovered from the original forum.
Post 11 by TBird,
#11may be you guys can help... I went ahead and ordered some bolt in 10X1.5 for the spools. Picture supplied, yet the bolt does not seem to fit it screws in a bit then it gets hard....
any idea?
Thanks.
any idea?
Thanks.
Post 12 by snow,
#12Post missing
This post could not be recovered from the original forum.
Post 13 by Twisted Jester,
#13I have received and installed the KTMTWINS swingarm spools:
They work great, fit is good with supplied spacers. Total was under $40. Was just using 10x1.5 bolts and taking them out when not on stand, that only cost $2.
They work great, fit is good with supplied spacers. Total was under $40. Was just using 10x1.5 bolts and taking them out when not on stand, that only cost $2.
Post 14 by arashi,
#14I have received and installed the KTMTWINS swingarm spools:
They work great, fit is good with supplied spacers. Total was under $40. Was just using 10x1.5 bolts and taking them out when not on stand, that only cost $2.
They work great, fit is good with supplied spacers. Total was under $40. Was just using 10x1.5 bolts and taking them out when not on stand, that only cost $2.
Post 15 by Twisted Jester,
#15I've got the Cycle Control spools, very nice. I'm sure they're std 1.5 thread, I even had to replace one. I did lube them a lot. Don't force them too much, but I think one of mine was tight, I think I used oil to get it going - I used ss bolts.
Post 16 by cjc,
#16Post missing
This post could not be recovered from the original forum.
Post 17 by 990EXODUS,
#17Post missing
This post could not be recovered from the original forum.
Post 18 by arashi,
#18Post missing
This post could not be recovered from the original forum.
Post 19 by cjc,
#19Post missing
This post could not be recovered from the original forum.
Post 20 by Twisted Jester,
#20Post missing
This post could not be recovered from the original forum.
End of archived topic · Posting is closedBack to top ↑
← Back to Technical - Dr F's Words of Wisdom