Read-only archiveOriginal forum posts · 2005–2020

tyre pressures Metzeler m3's

9 posts · Started by barleymo · 14 Nov 2009

Archived topic · Replies closedJump to last post ↓

Post 1 by barleymo,

#1
Post missing

This post could not be recovered from the original forum.

Post 2 by VegasSD,

#2
Post missing

This post could not be recovered from the original forum.

Post 3 by barleymo,

#3
Post missing

This post could not be recovered from the original forum.

Post 4 by barleymo,

#4
Post missing

This post could not be recovered from the original forum.

Post 5 by Agent Orange,

#5
Post missing

This post could not be recovered from the original forum.

Post 6 by barleymo,

#6
Post missing

This post could not be recovered from the original forum.

Post 7 by TheJoker,

#7
Post missing

This post could not be recovered from the original forum.

Post 8 by barleymo,

#8
Loved the M3s on my K1200R. Run standard pressures to start off with, and back off to get more "feeling". They tend to get a bit spongy/smeary when they get hot, but I liked this as they were really predictable.
They can go quite low without being too bad - however they tend to overheat and then the smeary/spongy thing gets worse.

Post 9 by barleymo,

#9
Post missing

This post could not be recovered from the original forum.

End of archived topic · Posting is closedBack to top ↑
← Back to Technical - Dr F's Words of Wisdom